Daihatsu Hijet parts
Model code S200P
Change
2 parts
for S200P
New
Brake Components
Daihatsu Hijet / Atrai Front Brake Rotors
Front brake rotors for the Daihatsu Hijet and Atrai, covering the S200 and S210 series kei platforms.
Kei truck and van front discs are small and light, which means they heat quickly and are unusually sensitive to being run past their minimum thickness. On a vehicle this size a disc that has been skimmed once or has worn a deep outer lip should simply be replaced, there is very little material to work with in the first place.
Replace rotors in axle pairs so braking stays balanced side to side, and fit new pads at the same time. Clean the hub face back to bare metal before mounting: rust or debris trapped between hub and rotor is the most common cause of runout and the brake judder that follows it.
Available in Hapad and Pitwork depending on stock, please ask which is currently on the shelf if you have a preference.
New
Only 3 left
JDM Ignition Coils
Daihatsu Hijet Ignition Coil
Ignition coil for the Daihatsu Hijet, part number 90048-52126, covering the S200P and S210P chassis codes.
These are individual coil-on-plug units, one per cylinder, sitting directly on top of each spark plug. A failing coil produces a misfire that is characteristically worse under load and when the engine is hot, along with rough idle, poor economy and a flashing check-engine light in the worst cases. Because each coil serves one cylinder, a fault is usually isolated to a single cylinder rather than affecting the whole engine.
Coils fail from heat cycling and age, so on a high-mileage Hijet where one has gone the others are usually not far behind, many owners replace all of them at once rather than returning to the job repeatedly.
Always fit new spark plugs at the same time. A worn plug with an excessive gap forces the coil to work at a higher voltage and is a common cause of repeat coil failure.