Toyota ALPHARD parts
Model code MNH15
Change
4 parts
for MNH15
New
Brake Pads and Shoes
Toyota Alphard Rear Brake Pads (MNH / ANH10 / ANH15)
Rear brake pad set for the first-generation Toyota Alphard, the 10-series built between 2002 and 2008, covering both the four-cylinder ANH and V6 MNH variants.
Rear pads on the 10-series Alphard wear far more slowly than the fronts, so they are often overlooked entirely. That neglect is what causes the two common failures on this axle: the pad backing plates corrode and swell where they sit in the caliper carrier, and the slide pins seize from lack of use. Either will hold the pad lightly against the disc, producing a hot wheel, a faint burning smell and rapid uneven wear.
When fitting, clean the caliper carrier abutments back to bare metal, re-grease the slide pins, and check that the pads move freely in their seats before refitting the wheel. Replace as an axle set.
Fits ANH10, ANH15, MNH10 and MNH15.
New
Only 1 left
Front Windshields
Toyota Alphard Front Windshield
Front windshield glass for the first-generation Toyota Alphard, the 10-series produced from 2002 to 2008. Laminated safety glass cut to factory dimensions for a direct glue-in replacement with no trimming or modification.
Laminated construction means two layers of glass bonded to an interlayer, so a stone strike cracks the outer layer without the screen coming apart. That same interlayer is a structural part of the vehicle: on a modern monocoque the bonded screen contributes meaningfully to roof strength and to correct airbag deployment, which is why a properly bonded fit matters more than it might appear.
This is a bonded installation and should be fitted by a glazier with the correct urethane and primer. Allow the adhesive its full safe-drive-away time before the vehicle returns to the road.
Fits ANH10, ANH15, MNH10 and MNH15. Please confirm your mirror mount, sensor and shade-band requirements before ordering, as these vary by trim.
New
Only 2 left
Suspension
Toyota Alphard / Estima Rear Axle Bushing
Genuine Toyota rear axle bushing, part number 48725-58010, covering the 10-series Alphard, the ACR30/ACR40 Estima, the Isis and the Previa.
This bushing locates the rear suspension to the body while allowing controlled movement. As the rubber perishes the axle gains unwanted lateral compliance, and the symptoms are the ones owners usually blame on tyres or alignment: a vague, wandering rear end, a clunk over bumps or on turn-in, uneven rear tyre wear, and a rear alignment that will not stay where it is set.
On vehicles of this age and weight these are a routine wear item. Replace them in pairs rather than singly, as a new bushing working against a perished one on the opposite side gives an inconsistent result.
Pressing is required, and a rear wheel alignment afterwards is necessary rather than optional.
New
Suspension
Toyota Alphard / Estima Lower Control Arm Damper
Genuine Toyota lower control arm damper, part number 48724-44010, covering the 10-series Alphard and the ACR30/ACR40 Estima.
This damper is a bonded rubber component that controls fore-and-aft movement of the lower control arm under braking and acceleration. It is not a ride-comfort item, its job is to stop the arm deflecting under load, which is what keeps the steering geometry stable when the brakes are applied.
When it perishes the arm gains longitudinal movement and the symptoms show up under braking specifically: a shudder or judder through the steering when slowing, a clunk on the brakes, and uneven front tyre wear. Owners frequently mistake this for warped discs and replace the brakes without effect.
Replace in pairs. Pressing is required, and a wheel alignment afterwards is necessary.