Toyota Grand Hiace parts

Fits all Grand Hiace codes Pick a code
18 parts for the Grand Hiace
No image available
New Only 2 left
Front Suspension & Bearings
Toyota Grand Hiace / Hiace Front Lower Ball Joint
New
Front lower ball joint, Toyota part number 43330-29305, covering the Grand Hiace KCH16, VCH16 and VCH28 and the Hiace KZH106, KZH116 and KZH126. The lower ball joint carries the vehicle's weight through the steering knuckle while allowing the wheel to steer and the suspension to move. It is a genuine safety-critical component: a ball joint that separates completely allows the wheel to collapse under the arch, with obvious consequences. Warning signs are a knock from the front over bumps or on full lock, vibration through the steering, and uneven or feathered front tyre wear. The definitive check is for play with the suspension unloaded and the wheel rocked top to bottom. Replace in pairs. A press or ball joint separator is required, and a wheel alignment afterwards is necessary. Fit a new split pin to the castellated nut, never reuse the old one.
No image available
New Only 1 left
Engine Parts
Toyota Grand Hiace Engine Mounting Bracket
New
Genuine Toyota engine mounting bracket, part number 12303-54071, for the Grand Hiace across both the VCH petrol and KCH diesel chassis codes. This is the steel bracket that carries the rubber mount, not the mount itself. Brackets rarely fail on their own, but they do crack where they have been loaded by a collapsed mount, and they corrode on vehicles that have spent their life on salted or coastal roads. A cracked bracket produces the same symptoms as a failed mount, vibration and engine movement, and replacing the mount alone will not fix it. Inspect the bracket whenever a mount is replaced. If you are fitting a new mount to a bracket that shows cracking around its fastener holes or heavy corrosion, replace both together. Support the engine properly before removing the bracket, and torque the fasteners to specification on reassembly.
No image available
New Only 1 left
Suspension
Toyota Grand Hiace / Hiace Front Upper Suspension Arm Set (LH & RH)
New
Genuine Toyota front upper suspension arm set, part number 48066-29105, supplied as a matched left and right pair. Covers the Grand Hiace VCH and KCH codes and the Hiace KZH106, KZH120, KZH126, RZH109 and RZH119. On a double-wishbone front end the upper arm sets camber and caster geometry and carries the upper ball joint. Wear appears in two places, the arm's pivot bushings and the ball joint itself, and both produce the same complaints: a knock from the front over bumps, wandering steering, uneven front tyre wear, and an alignment that drifts out of specification. Supplied as a left and right set, which is how they should be replaced, fitting one new arm against a worn one gives asymmetric geometry and an alignment that cannot be corrected properly. A full wheel alignment after fitting is required, not optional.
No image available
New Only 3 left
Engine Oil Filters
Toyota Oil Filter (Commercial & Van Range)
New
Genuine Toyota oil filter, part number 04152-38010, one of the most widely applied filters in the modern Toyota range. Stocked here for the commercial and van platforms we supply: Hiace and Regius Ace, Grand Hiace, Dyna, Coaster, Land Cruiser, Hilux, Town Ace and Century. This is a cartridge-type filter rather than a spin-on, supplied as the paper element with its sealing rings. The housing stays on the engine and is reused, which means the O-rings supplied with the element must be replaced every time and lightly oiled before assembly. Reusing an old, hardened O-ring is the single most common cause of a leak after an oil change on these engines. Change the filter with every oil service. The cartridge housing has a specified torque, and overtightening it splits the housing, a genuinely expensive mistake on an engine where the housing is plastic. Covers all TRH-series Hiace models.
No image available
New Only 1 left
Timing Belts
Toyota Grand Hiace / Hilux / Prado Timing Belt
New
Timing belt for the Toyota Grand Hiace VCH, plus Hilux, Hilux Surf and Land Cruiser Prado applications. DriveJoy part under Toyota number 13568-69095. The timing belt synchronises crankshaft and camshaft rotation. On an interference engine a snapped belt lets pistons and valves occupy the same space, and the result is bent valves and frequently a damaged head, which is why the belt is replaced on a time and mileage schedule rather than on condition. There is no reliable way to inspect a belt and conclude it has another 50,000 km left in it. Replace the tensioner, idlers and water pump at the same time. All of them sit behind the belt, all have a similar service life, and doing them separately means paying the same substantial labour bill twice. Note this fits the Grand Hiace VCH petrol V6 only, not the KCH diesel.
Toyota HiAce Aire Filter (ELEMENT)
Only 3 left
AIR ELEMENT
Toyota HiAce Aire Filter (ELEMENT)
Aftermarket New
This Part is Compatible With the Following Vehicle Vin No Starting: VCH22 /28 VCH10/16 KCH10/16