Honda Odyssey parts
Model code RB1
Change
3 parts
for RB1
New
Only 3 left
Front Windshields
Honda Odyssey Front Windshield
Front windshield glass for the Honda Odyssey RB3 and RB4, built between 2008 and 2013. Laminated safety glass cut to factory dimensions for a direct glue-in replacement.
The RB3/RB4 Odyssey is a low-roof MPV with a large, shallow-raked screen. As with any modern bonded windshield, the glass is a structural component: it stiffens the body shell, contributes to roof crush resistance, and acts as the reaction surface for passenger airbag deployment. A correctly bonded fit is a safety matter rather than a cosmetic one.
Bonded installation requiring the correct urethane adhesive and primer, and professional fitting. Allow the adhesive its full safe-drive-away time before the vehicle returns to the road.
Fits RB3 and RB4. Please confirm your mirror mount, sensor and shade band requirements before ordering, as these vary by trim.
New
Brake Pads and Shoes
Honda Step-Wagon / Odyssey Rear Brake Pads
Rear brake pad set covering the RG-series Honda Step-Wagon and the RB-series Honda Odyssey, two platforms that share rear brake hardware.
Rear pads on these wear slowly, which in practice means they are usually replaced because the caliper has started to stick rather than because the friction material has run out. The rear caliper slides on both platforms are a known corrosion point, and a seized slide holds the pad against the disc, producing heat, smell and rapid one-sided wear.
Fit as an axle set. Strip, clean and re-grease the slides, and confirm both pads move freely in the carrier before refitting. If the disc is scored or has a heavy outer lip, replace it, a new pad on a ridged disc will never bed properly.
Fits Step-Wagon RG1 to RG4 and Odyssey RB1 to RB4.
New
Brake Pads and Shoes
Honda Step-Wagon / Odyssey Front Brake Pads
Front brake pad set covering the RG-series Honda Step-Wagon and the RB-series Honda Odyssey. The companion front set to part 43022-SFE-N00.
The fronts on both platforms do the bulk of the braking and wear accordingly, typically two to three times faster than the rears. Wear is usually even, and the first sign is the wear indicator squealing under light braking.
Fit as an axle set and check disc thickness against the minimum stamped on the disc hub while the caliper is off. A pedal pulsation on these is almost always disc runout rather than a pad problem, and fitting new pads to a warped disc will not fix it.
Fits Step-Wagon RG1 to RG4 and Odyssey RB1 to RB4.